ARESTA Ladder Yoke 1.3m - 15kn - 25mm - [XE-AR-LY013]

ARESTA Leaning Ladder System: Installation & Rigging Process

1. Attach the rope to the ladder: Ground Preparation Thread the ARESTA 10m static kernmantle rope over the top rung of the ladder (never over a V-bracket or pole bracket). Secure it tightly, ensuring the rest of the line falls straight down the underside/working side of the ladder.
2. Position the ladder: Erecting Erect the ladder to your required height, positioning it slightly to the side of your intended working area using the ARESTA Leaning Ladder System framework.
3. Drill & fit the anchor bolt: Structural Anchorage Drill your structural fixing point using a 12.5mm masonry bit. Hand-tighten the reusable ARESTA Ladder Tie Bolt clockwise into the hole until the expansion sleeve grips, pulling the eyebolt ring flush and completely secure against the structure.
4. Secure the ladder with the Yoke: System Tensioning Fit the ARESTA Hi-Vis Ladder Yoke around both stiles. Use the 90-degree hand method (aligning your index finger with the pitch of the ladder so your thumb points toward the anchor bolt) to select the perfect rung height. Connect the ARESTA 3m high-vis strap via its cam-lock between the ARESTA Hi-Vis Ladder Yoke and the wall anchor, pulling it firmly toward you to tension the ladder tight against the structure.
5. Tension the vertical line: Line Security Tie off the bottom end of the ARESTA 10m static kernmantle rope to the second rung from the bottom on the underside of the ladder, ensuring the vertical line is fully tensioned and straight.
6. Connect personal protection: Final Safety Check Don your ARESTA 2-point full body harness. Attach the ARESTA Rope Grab device to the vertical kernmantle rope, and lock its twist-lock karabiner directly into your front sternal D-ring.